![]() ![]() As an example, this tutorial will deal with mounting a pair of TTS bindings. If no jig is available, remember that without a mounting jig, the carpenter’s rule rules. ![]() Luckily, this doesn’t prevent us from reusing drill holes as binding hole diameters have seemingly standardized at 6mm, while screw thread diameters are set at 5.5mm, leaving a half-millimeter of wiggle room. The astute will notice a half-millimeter discrepancy in some toe-hole lengths: 26.5 vs 27mm. Once you know where to mount, if at all possible, borrow a jig for mounting your binding.ĭIY mounting installation of tech skiing bindings such as Dynafit Radical, TLT, Speed and others, paper template jig included in this how to article and blog post. For use as a dedicated powder ski, moving the mount point back about 1 cm is pretty common. If you’re in the terrain park a lot and land switch, you might move the binding as much as 3cm forward. ![]() The only variation to this is generally to mount the binding forward. In general, the manufacturers recommendation is for the boot center mark to match up with a corresponding boot center mark on the ski. Line up ski boot center with the corresponding mark on the ski.Figure out where you want your foot located on the ski. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |